NASA SBIR 2018-I Solicitation

Proposal Summary

 18-1- A1.08-2622
 Aeronautics Ground Test and Measurement Technologies
 Capacitive Vector Skin Friction Measurement Systems for Complex Flow Fields
SMALL BUSINESS CONCERN (Firm Name, Mail Address, City/State/Zip, Phone)
Interdisciplinary Consulting Corporation
5745 Southwest 75th Street, #364
Gainesville , FL 32608-5504
(352) 359-7796

Principal Investigator (Name, E-mail, Mail Address, City/State/Zip, Phone)
David Mills
5745 Southwest 75th Street, #364 Gainesville, FL 32608 - 5504
(812) 204-9206

Business Official (Name, E-mail, Mail Address, City/State/Zip, Phone)
Leonard Kubik
5745 Southwest 75th Street, #364 Gainesville, FL 32608 - 5504
(256) 960-9520
Estimated Technology Readiness Level (TRL) :
Begin: 3
End: 4
Technical Abstract

The Interdisciplinary Consulting Corporation (IC2) proposes to develop dual-axis shear stress sensors that are applicable in ground test facilities covering a large range of flow speeds in response to NASA SBIR 2018 Phase I solicitation subtopic A1.08: Aeronautics Ground Test and Measurements Technologies. The proposed sensing system addresses a critically unmet measurement need in NASA’s technology portfolio, specifically the ability to make time-resolved, continuous, direct, two-dimensional measurements of mean and fluctuating wall shear stress in wall-bounded turbulent and transitional flows in subsonic and transonic facilities. The realization of this capability not only benefits advanced air vehicle development but also impacts fundamental compressible boundary layer physics research areas such as transition to turbulence in three-dimensional flows, extending the current capabilities of NASA’s ground test facilities.

The proposed innovation is a dual-axis, instrumentation-grade, robust, high-bandwidth, high-resolution, silicon micromachined differential capacitive shear stress sensor for subsonic and transonic applications. The sensor system will enable localized, non-intrusive, vector measurement of mean and fluctuating wall shear stress for characterization of complex boundary-layer flows in ground-test facilities. The differential capacitive measurement scheme offers high sensitivity to in-plane shear stress as well as common-mode rejection of pressure fluctuations. Two sets of differential capacitors provide shear stress measurement capability in two orthogonal directions to provide the wall shear stress vector. Backside electrical contacts using IC2’s patent-pending fabrication and packaging process enable the sensor to remain flush with the test article surface while significantly reducing fabrication complexity and cost. The modeling aspects of the proposed design approach facilitate design optimization for various applications and flow conditions.

Potential NASA Applications

The proposed technology enables dual-axis wall shear stress measurement in a wide range of subsonic to transonic test facilities including: NASA Langley Research Center's 14' by 22' Subsonic Wind Tunnel, Basic Aerodynamics Research Tunnel (BART), and 16' Transonic Dynamic Tunnel; the 9' x 15' Low-Speed Wind Tunnel at NASA Glenn Research Center; and the 11' x 11' Transonic Unitary Plan Wind Tunnel at NASA Ames Research Center.

Potential Non-NASA Applications

Customers seeking or currently designing next-generation civilian or defense aircraft have a similar measurement need.  Furthermore, active flow control (a rapidly growing area of research and development) requires compact, accurate measurements of key fluid dynamic parameters such as wall shear stress.  Non-NASA applications include:

Form Generated on 05/25/2018 11:27:15